Car bumpers: AHSS steels reduce weight, increase crash performance

With the stick-in concept, the anchor plate of the crash box (can) is eliminated to save bumper system weight while achieving the required crash performance.

Saving bumper weight with “stick-in” crash boxes

Car bumper OEMs are realizing weight savings by eliminating the anchor plate of the crush box (or “crush can”) and instead “sticking” the boxes into the rails. The boxes are then screw fastened in the Y direction. In one example, eliminating the two anchor plates reduced the weight of the entire front bumper system by 2.5 kg. Suggested steel grades for the crash box include Docol^® HR800CP or Docol^® CR800DP.

This bumper beam, made in Docol^® PHS 2000, reduced the weight of the bumper system by 17%.

17% lighter bumper beam helps meet fuel efficiency standards

By increasing the strength of the bumper beam from PHS 1500 MPa to Docol^® PHS 2000, this bumper manufacturer realized a 17% weight reduction – making it lighter than more costly aluminum. The new PHS 2000 bumper beam helped the auto OEM meet both fuel and emissions requirements.

 The blue indicates Docol^® CR 1000DP bumper beam, while the green is the Docol^® 800DP lower load path crossmember.

Cold-formed solutions for steel bumper beams

Looking for additional cost and weight savings in your bumper system? Consider high-strength, cold-formed steel options. In this example, a bumper beam’s PHS 1500 MPa steel was replaced with Docol^® CR 1000DP, eliminating the expensive and time-consuming hot-forming process.